All Jambs are Supplied Pre Primed (Gesso Coated)
Required Tools and Accessories
Door Hinged x 2
Both Faces Primed
4 Edges Un Primed
No attached Plates
Door Stop to Jamb
Retail: 710 Duo Door Double
Drill and Phillips Drill Bit
For connecting Side and Top Jambs
For attaching door to jamb using
Quick Door Hanger
Spirit Level and Pencil
For Marking Straight Line on
Plaster Board Prior to installing
Duo Door in Final Position with QDH
Quick Door Hanger
Install your door in
under 5 Minutes
Connecting Door Stop to Jamb
Slide the top Jamb under both side Jambs.Ensure that the Hinge Button is facing up.
When making a Double door, they are both Left and Right Hung in the same door. Just follow the instructions, each door scetion will need to be replicated for each hanging, yet the frame is made as one piece.
Lay door on ground next to Door Jamb with Hinge Piece on. Have both hinge pieces facing up, slide pieces into place.
Position each hinge piece as pictured.
Place pin in top and slide in hinge. Slight tapping with hammer may be required.
Repeat for all six hinges.
Lay flat on floor so that all sides are in line. Screw the smaller screws into the the three outer holes (as Pictured). Once completed, screw the longer screw piece into the top remaining side hole. Pre drill 2mm guide hole first.
You have a Pre Hung Double Door
Now to Install the Door
6: Grab the Quick Door Hanger and follow the instructions. Click Here.
Your Door is now Installed
Now to add Door Stops
Position Both doors in a closed position, hold door in closed position.
Line up supplied door stops and nail them to Jamb in the position required.
Remember they are there to stop to door so position them where you want the door to close too.
Non Hinged Side
Positioning of Stops