All Jambs are Supplied Pre Primed (Gesso Coated)

Required Tools and Accessories

Side Jambs

Hinged

Connector Plates

pre attached

Screws Included

Door Pre Cut x 2

Both Faces Primed

4 Edges Un Primed

Top Jamb

No attached Plates

Connector Plate

Assembly Instructions

Sliding Door Double

Drill and Phillips Drill Bit

For connecting Side and Top Jambs

For attaching door to jamb using 

Quick Door Hanger

Tape Measure

Undercoat and Brush

All four edges of door 

requires priming prior to install for Warranty.

Supplied Parts

4: 

Slide the top Jamb under both side Jambs.

1: 

Remove Packaging, please dispose of carefully,  paint all four edges of both doors with primer to ensure warranty of door.

5:

Lay flat on floor so that all sides are in line. Screw the smaller screws into the the three outer holes (as Pictured). Once completed, screw the longer screw piece into the top remaining side hole. Pre drill 2mm guide hole first.

3:

Measure width of Opening, cut top Jamb piece to width less 50mm.

6: 

Attach Constructed Jamb to Stud in Position. Ensure Spacing at top of opening is equal to the bottom. Door Jamb is supplied correct to height. Any variation from this should be double checked.

2:

Before starting any work, please read this document for Installation details of slider.

7: 

Cut Robemaker Tracks (Top and Bottom) to Fit space. Should be equal to width of Top Jamb Cut +/- 3mm.

8: 

Follow These Instructions. Click on this Tab.

Hacksaw