All Jambs are Supplied Pre Primed (Gesso Coated)

Required Tools and Accessories

Side Jambs

Hinged

Connector Plates

pre attached

Screws Included

Door Pre Cut x 2

Pre Cut for Rollers

Both Faces Primed

4 Edges Un Primed

Top Jamb

No attached Plates

Connector Plate

Assembly Instructions

There are two types of Duo Door Design

The Standard option and a more complete version called the Duo Deluxe

Both are designed to save Time and Money.

Triple Slider

Drill and Phillips Drill Bit

For connecting Side and Top Jambs

For attaching door to jamb using 

Quick Door Hanger

Tape Measure

Undercoat and Brush

All four edges of door 

requires priming prior to install for Warranty.

Supplied Parts

4: 

Slide the top Jamb under both side Jambs

1: 

Remove Packaging, please dispose of carefully,  paint all four edges of both doors with primer to ensure warranty of door.

8: On the non hinged side of door, hold door in closed position.

Line up supplied door stops and nail then to Jamb in the  position required.

5:

Lay flat on floor so that all sides are in line. Screw the smaller screws into the the three outer holes (as Pictured). Once completed, screw the longer screw piece into the top remaining side hole. Pre drill 2mm guide hole first.

You have a Pre Hung Double Door

  Now to Install the Door

7: Grab the Quick Door Hanger and follow the instructions.                               Click Here.

Your Door is now Installed

Now to add Door Stops

DISPLAY BAG.png

8: 

Position Both doors in a closed position, hold door in closed position.

Line up supplied door stops and nail them to Jamb in the  position required.

Remember they are there  to stop to door so position them where you want the door to close too.

Non Hinged Side

Positioning of Stops

FinishedLook

3:

Measure width of Opening, cut top Jamb piece to width less 50mm.

6: 

Attach Constructed Jamb to Stud in Position. Ensure Spacing at top of opening is equal to the bottom. Door Jamb is supplied correct to height. Any variation from this should be double checked.

2:

Before starting any work, please read this document for Installation details of slider.

7: 

Cut Robemaker Tracks (Top and Bottom) to Fit space. Should be equal to width of Top Jamb Cut +/- 3mm.

8: 

Follow These Instructions. Click on this Tab.

Hacksaw